Integration

ETC controllers are equipped with one or more digital outputs. These digital outputs can be turned on and off to signal to other systems, provide power to external devices, or run relays to turn higher power devices on and off.

The simulator is based on the same software as the controller and therefore supports all of the same features. If...

Vision Device Management can connect to a physical controller using a serial port or to the simulator using TCP. The...

Modbus is a standard communication protocol that is supported by many devices. All ETC plunger lift controllers use COM1 as...

Vision Device Management is a tool provided by ETC that allows you to interact with our controls and sensors. Video...

The output signal (SIG) on the Cyclops IS, Cyclops ExP, and Sasquatch are designed as a dry contact. This means...

There are a number of common problems that can happen when trying to use Modbus with the ALiEn2 or Sasquatch....

The ALiEn2 line of controllers will work with any SCADA system that supports standard Modbus. You can choose to implement...

The solar enclosure has internal mounting points engineered into so it can be used as a housing for electronics. Detailed...

The Sasquatch calculates the surface velocity of the plunger on each arrival event. This is stored in a log with...

The Sasquatch uses the same Geomagnetic Sensing Technology that is found in the Cyclops. Instead of having a single eye,...

ETC controllers that support Modbus have multiple options for storing date/time as well as elapsed time. This allows you to...

The ALiEn2 and ALiEn2 Expert has a set of built in features that can be used to track the wear...

Autosol has taken their standard Modbus driver and created a version specific to the ALiEn2 that helps to retrieve both...

Overview Sasquatch works by watching a ferrous plunger go by in real time, correlating multiple key points on two separate...