Is there a software simulator for the ALiEn2/ALiEn2 Expert?
There is a full simulator for the ALiEn2/ALiEn2 Expert plunger lift controller that is built from the software that runs...
Operation
Get help operating an ETC product correctly and efficiently.
-
-
Why does my Cyclops keep fast tripping?
There a number of potential reasons that a Cyclops could trip at an unexpected time. Here are the most common... -
How do I use load factor with the ALiEN2 Expert to open the well?
Load factor is a built in feature that allows you to open the well based on it’s ability to lift... -
What is Geomagnetic Sensing?
Geomagnetic sensing is a technology that uses a magnetometer and a microprocessor to read the Earth’s magnetic field and look... -
How can I configure the ALiEn2 Expert to operate a Gas Assisted Plunger Lift (GAPL) well?
While the ALiEn2 was designed as a plunger lift controller, the Expert level model does have additional valves that can... -
How does the Cyclops work?
The Cyclops uses Geomagnetic Sensing to read the Earth’s magnetic field and then look for changes in the field to... -
How does adaptive seeking velocity optimization work?
The purpose of Adaptive Seeking Velocity Optimization is adjust the Afterflow Time and/or Close Time to influence the plunger to... -
How does the Sasquatch calculate and use the Kinetic Energy?
Fast plungers cause dangerous hard impacts at surface. The magnitude of the impact is not based on velocity of the... -
How does the Sasquatch work?
The Sasquatch uses the same Geomagnetic Sensing Technology that is found in the Cyclops. Instead of having a single eye,... -
How do I track plunger statistics with the ALiEn2?
The ALiEn2 and ALiEn2 Expert has a set of built in features that can be used to track the wear... -
How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
Use Vision to connect to the sensor. Click here for the steps. Ensure that the dial on the sensor is...
Submit a Support TicketSubmit a Ticket