1. Home
  2. Troubleshooting
  3. How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
  1. Home
  2. Tools
  3. Vision
  4. How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
  1. Home
  2. Products
  3. Cyclops IS/ExP
  4. How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
  1. Home
  2. Operation
  3. How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
  1. Home
  2. Products
  3. Sasquatch
  4. How do I reset Cyclops or Sasquatch to the normal operation mode from debug?
Searching...

How do I reset Cyclops or Sasquatch to the normal operation mode from debug?

  1. Use Vision to connect to the sensor. Click here for the steps.
  2. Ensure that the dial on the sensor is set to 0.
  3. Click the Normal Mode radio button
  4. Press Set Mode
  5. Turn the dial on the sensor back to a non-zero value before using it.

Updated on 23 June 2021
Tagged:

Was this article helpful?

Yes No

Related Articles

Submit a Support Ticket
Can’t find what you’re looking for? We’re here to help!
Submit a Ticket

Leave a Comment